Introduction to Panic Alarms

Objective

The purpose of a panic alarm is to permit an individual under duress to quickly and silently call for help in the occasion of an emergency. Panic alarms are additionally called “duress alarms”, “hold-up alarms”, or “panic buttons”.

Panic alarms are used when it may be unsafe or uncomfortable to call for assist in other ways. For instance, if a belligerent person is standing in your foyer, it may be unwise to additional escalate the situation by picking up a phone to call for assistance. A panic alarm can provide a quick and convenient way to summon help without drawing attention.

Silva Consultants feels that just about each business can benefit from using panic alarms. Places the place panic alarms may be particularly beneficial embody:

Receptionist’s desks in building lobbies.

Security stations and checkpoints.

Shipping/receiving areas.

Customer support counters.

Check-out counters and cashier’s stations.

Rooms where money or other valuables are obtained, processed, or stored.

Interview rooms in Human Resources department.

Executive office suites.

Places where confrontations with the general public are likely to occur.

Parts of a Panic Alarm System

Panic alarms encompass two basic components:

Panic Button

The panic button is the device that the individual prompts when he or she needs help. There are numerous types of panic buttons available. These can have a single pushbutton, pushbuttons that have to be pressed simultaneously, devices that should be squeezed, and gadgets which are activated by a foot or knee. There are also gadgets that can be covertly activated when money or a product is removed at the request of a robber. Most panic buttons are specifically designed to resist accidental activation.

Panic buttons are usually installed in a location where they will easily be reached, yet out of view of the informal observer. In many cases, panic buttons are put in on the underside of a desk or counter-top.

Panic buttons could be the wired type or wireless type. Wired panic buttons are connected using cabling. Wired panic buttons are very reliable, but it can generally be difficult and costly to get cable to each panic button location.

Wireless panic buttons use a brief-range radio transmitter, just like that used with a garage door opener. Wireless panic buttons are simple to put in and will be positioned just about anywhere. Wireless panic buttons will also be carried around on the premises by employees if desired. Wireless panic buttons require batteries and must be tested continuously to guarantee that they are operating properly.

Communications System

The communications system is the method that is used to summon help when a panic button is pressed. The type of communications system used depends largely on the resources available at the facility the place the panic alarm is being put in and the level of security threat.

Types of communications systems used can embrace:

Communications to an off-site alarm monitoring middle:

This method would typically be used at facilities that should not have an on-site security staff, reminiscent of at a small business. The panic buttons can be connected to an alarm management panel which sends a signal to the monitoring middle when a panic button is pressed. The alarm monitoring center would then call the police or other appropriate individuals to answer the site.

Communications to security management middle:

Most giant firms have some type of centralized security monitoring and management middle, either on-site, or at a central location somewhere within their organization. When this type of resource exists, panic buttons are typically monitored on the control center. Most often, panic buttons are related to the group’s access management and security management system, which transmits the alarm to the control center.

When a panic button is pressed, it sounds an alarm within the security management center. The middle would then dispatch local security officers and/or the police to reply to the site.

Communications to non-security personnel:

Some organizations that should not have on-site security choose to inform non-security personnel when a panic button is pressed. Usually, the group will form a “response crew” consisting of staff from a number of departments (Facilities, HR, etc.) and ask that these staff respond when a panic button is pressed.

There are numerous systems that can be utilized to notify the response crew when a panic button has been pressed. These embrace can embody overhead paging systems and units that ship voice messages, text messages, or email messages directly to smartphones.

Here’s more info in regards to Signal from workplace panic button look into our own web page.

Leave a Reply